Software Update 2.48.16 (2025 November Rain release)

[Kaiphi]

Update has been successfully installed on the Vertical 1. I think even without loss of a personalized sport mode. Sleep report when waking up in the new design. If I open it again, it will be in the old one. Had no battery problems before and not now. Just 2 hours on the bike with 1.3% per hour consumption with best gps.

[Josaiplu]

I’m currently get phantom vibration on my race 2, only suunto belt paired (fresh post update)
Watch vibrate without nothing displayed at all post activity
If I open the activity pre start page I see the belt already connected
I will soft reset and it will disappear but bug still here
The disconnect issue I suffer last time was gone after doing unpair/pair of the belt
I assume that battery drain can be caused by such behavior if the watch continue to look for BT devices after an exercice it is quite energy consuming

[Trashpanda]

Thx for the Info

[Trashpanda]

Thx for the Info

[Miguel Angel Moreno]

@ChrisA Yes, it is the Race I. The last update prior this one mess up the life battery. What I think is that the connection to multiple heart rate devices just have something to do with it. I expected that this update solved the issue but now it is even worst. Before these two updates I had to charge my device after 5 to 6 days depenging on my weekly training but now it is not even two days. I do not even have the notifications on. I came back to Suunto after the horrible experience with the Spartan series and I do not think I will repeat again with this brand.

[Stefan Kersting]

@Josaiplu I had the same problem too and reported it. But nothing was done with it. Think too that it’s part of the battery drain problem

[Miguel Angel Moreno]

@Josaiplu I am facing the same issue here. Everything is working fine if I use the Coros one, but with the Suunto HR belt it looses the connection multiple time in my last two work outs. I am not even sure that zone sense metrics are accurate after this update but unfortunately this is something that I cannot verify.

[Dimitrios Kanellopoulos]

@Stefan-Kersting afaik it wasn’t

[Dimitrios Kanellopoulos]

@Josaiplu is the sensor on the belt ?

[Josaiplu]

@Dimitrios-Kanellopoulos yes, I have then removed it and still get one vibration, I then go to the activity start menu and see my hr with the icon without the belt. I assume that the last vibration was related to the disconnection of the belt caused by removing the sensor of the belt

I have now done a soft reset and no more vibration

[pilleus]

No problems with the Bluetooth connection of two heart rate sensors and my Vertical. Two activities with more than two hours, Polar Verity Sense connected during the first activity, Huawei Fit 4 Pro connected during the second one.

No disconnection, no false values, everything was fine.

[ChrisA]

@Miguel-Angel-Moreno ah I see, thanks for the clarification. It seems to affect only some devices though. My Race I shows no signs of battery drain, but very annoying for those who have devices that drain ones battery that fast

[gone troppo]

Does anyone actually know what suunto has done to address the battery drain other than saying it’s fixed? Mine hasn’t changed one bit still draining approx 1% every 2 hours best case scenario.

I see it has been mentioned to let the battery drain and recharge before making final judgement I will do this however I’m 99.9% sure this does not make a single difference as I have already done that many times with no change. Why would it all of a sudden make this watch start working as it should? Doesn’t seem logical to me.