FusedTrack works great - for 16 Minutes or 2,5km
-
@Łukasz-Szmigiel Yes, a lot. Really strange
-
@VoiGAS and this is running right, not cycling?
-
@isazi Yes, and I just counted the “jumps” in the track - it is just one position marker per minute, nothing in between
I read the watch should request a compass calibration when Endurance mode is chosen. I never had a message like this -
@VoiGAS did you already try to reboot your watch?
-
@isazi No, I will try that
-
As far as I’m aware - this should always work for running activities in Endurance and Ultra if the watch has calibrated wrist movement to GPS, which typically takes one 15+ minutes run in Performance mode.
@isazi, will such data get refreshed with only a soft-reset?
-
@Łukasz-Szmigiel I would say that a reboot is the first step, then maybe a factory reset could be necessary. Hopefully not.
-
@isazi ok, so Soft Reset + AGPS Sync (then wait 15 Minutes) + 15 Minutes Performance Run to calibrate + Compass Calibration + Endurance Run is the way to go . This will be one of my most intense training weeks
-
@VoiGAS remember to sync the watch after soft reset and then wait 15 minutes in order for the watch to unpack the AGPS data.
-
Soft Reset & Performance Run done, next Test on friday for FusedTrack. Funfact: Ray tested FusedTrack in a 10 Minute Run. Guess what - it worked great
https://analyze.dcrainmaker.com/#/public/1e2d78d0-2e27-4219-7a46-9e64e4526069 -
@VoiGAS honestly not sure if the watch was doing 15 minutes of performance when in endurance mode at that time (2018, the time S9/S9B were introduced). As you can see from the track, the watch was not in performance mode.
-
@isazi How can you see it was not it performance mode? Is this maybe something I can analyze for my own runs? I just tried it with the GPX (Workout) Export and like expected it is showing 1-3 second intervalls for the first 17 (strange, really 17 and not 15) minutes and afterwards just one position entry per minute
Edit I mean the old, faulty one. After the reset I still have to try
-
@VoiGAS because the track would be much better if it was in performance mode.
-
Soft Reset did not work, same 1 Minute Jumps like before
️. Worst thing is that it completly cuts the last meters that way. If it would just sync GPS at the end.
Next station Hard Reset, I hope it helps -
Update after Hard Reset: At the end of the Calibration (Performance Mode) Run the watch showed a message “Laufen kalibriert” (running calibrated). This message didn’t show up after the soft reset, so I keep my fingers crossed for tomorrow…
-
@isazi @Łukasz-Szmigiel Unfortunatly it didn’t work. I also noticed that the pace was way off, it showed 7:00 to 11:00min/km during the run. So also FusedSpeed doesn’t work. Thats really a bummer as the Fused Algorithms are Suuntos USP and I really like to use them.
I guess the accelerometer is defective - hopefully Suunto can repair it️ -
Update after I sent the watch to Suunto for repair: No defect, I should try to do a calibration run and the watch is already on the way home
Somehow I expected it to be this way, but still I’m disappointed. I like Suuntos idea with FusedTrack, but I think it should also work… -
Also after the supports actions it doesn’t work. My theory is that FusedTrack doesn’t exist anymore, at least not on S9 Peak https://forum.suunto.com/post/149960
So this thread can be closed -
@VoiGAS said in FusedTrack works great - for 16 Minutes or 2,5km:
Also after the supports actions it doesn’t work. My theory is that FusedTrack doesn’t exist anymore, at least not on S9 Peak https://forum.suunto.com/post/149960
So this thread can be closedI checked an old manual I have against a new one, you are correct. I will test this by tomorrow. I have my 9Peak and Suunto 9baro charging to see if both behave the same way. I’ll report back here for you.
-
@Brad_Olwin How did it go? Great that you have such an impression Suunto collection for comparsions
