S9B Strange HR and HR-Zones behavior
-
@brad_olwin Well, I did the reset and have good news - the problem with the stuck zone is gone. Did a few tests and it behaves normally now
-
Hello everyone. I have the same problems when I train with the chest HRM. The firmware is up to date, the heart rate monitor battery is new, I wet the HR belt several times during training, but the heart rate was inadequate. I had set up HRZ4, I had turned on training peaks - cycling power, which all the time showed rtss 0.00, NP 0 (That I also don’t know why, but I understand it’s another topic). The next workout I will try at the same settings, but with OpticHRS. I haven’t reset the watch yet. It would be grateful if anyone would comment on these issues. I wish everyone health!
-
@ingiliz as you see the problem that @tomasbartko had was that HR was stuck in Z4 on the watch, even without HR being measured. So you need to test with OHR and with no HR at all before we can say if it’s the same issue, or just a broken HR strap.
-
@isazi Thank you for the rapid response. Until ten days ago I used the same chest belt with traverse alpha and I believe it. Today I just checked the battery.
-
