Alarm during sleeping hours ?
-
@freeheeler hi !
I set a sleeping hours of 23:30-07:05 and set an alarm for “once” at 06:30I have tones on the alarm but it didn’t ring . I was already awake though. This is the 3rd time I noticed . When the alarm is after the sleeping hours it is working fine
-
@thanasis
I’ll set it up the same way and try to replicate. I’ll keep you posted -
@thanasis my auto DnD is set between 23 and 8 every day, and every time I need the alarm is before that (otherwise I use my home alarm). Last time I used it is this morning, and it woke me up.
-
@isazi I am resetting the figures as mentioned and I will replicate it
I cannot understand if there is something wrong with it at my end but I really cannot figure this out
-
@thanasis said in Alarm during sleeping hours ?:
@isazi interesting … it’s not working in my case . Are you sure the alarm is set on a time within the sleeping hours ??
Mine is. Are you setting auto-DND or manually enabling DND? My sleep hours are set from 10pm to 6:30 am and this morning I set an alarm for 5:30 am.it worked fine.
-
@thanasis I would set vibration too! The tones are not loud…
-
@thanasis
good morning, just woke up by the alarm while auto DND was still active -
@freeheeler @Brad_Olwin @isazi thank you all
I will reset my settings and try this again. Today it didn’t ring either
-
Hello again,
after resetting the watch’s settings , it worked.
i still feel thought that there is something causing this instability, but since it is fixed I am happy with it
-
@thanasis
please observe it and report immediately if it should happen again. You can then also contribute in sending logs.
but let’s hope it’s solved -
Bringing back this topic …
Last night I left my S9p next to my bed with the alarm to ring at 06:59. The watch apparently went into sleep or something and the alarm rang when I picked it up at 07:51 (completely random time ) and not in timePlease note that I have disabled the HR readings and the DND and sleeping hours
Does anyone have the same or it’s just my watch with that issue ?
Thanks
-
@thanasis I am reporting this and asking.
-
@Dimitrios-Kanellopoulos thanks Dimitri
-
@freeheeler a silly question: how do you enable “auto DnD” (as opposed to a “manual DnD” mode)?
-
@MdzOtt it is in the sleep settings
-
@thanasis could you please send logs if you can repro this ? I tried with no luck. Reported though and team asked for log s
-
@Dimitrios-Kanellopoulos Sure!
i will try to reproduce it tonightI think the case is:
- Disable HR & sleep tracking on the watch
- Leave the watch in location where it stays idle (should not get any movement to enter this “low power mode”).
- Leave your mobile without Bluetooth or out of range of the watch
- Set an alarm for “Once” in X hours
- Be patient
I will send the logs tomorrow morning
-
@thanasis thank you very much
-
@Dimitrios-Kanellopoulos said in Alarm during sleeping hours ?:
@thanasis thank you very much
I just Reproduced it as stated
Logs sent just 2min ago
ThanksPs sent them 2 times , because the alarm rang after sending the first log set so I resent them right after again
-
@thanasis thank you
-