Training, intensity target zones, issue for multisport activity

[sartoric]

Yesterday I’ve found a strange behaviour. I was doing a multisport activity (trekking + run)

I’ve set HR zones for trekking, then once switched to run I’ve set Pace zone.

The problem is that switching back to trekking , the HR target was screwed up, The HR display shown just dashes (not even instant HR) and it has a strange looking.
Of course setting the target again fix the issue.

I can understand that the pace target is not available for trekking, but it should be nice to have at least the default hr view working

[Brad_Olwin]

@sartoric Do you have Default and Specific HR zones set (i.e. running and cycling)? If you did not set Default then the watch may not know the targets

[sartoric]

@Brad_Olwin said in Training, intensity target zones, issue for multisport activity:

@sartoric Do you have Default and Specific HR zones set (i.e. running and cycling)? If you did not set Default then the watch may not know the targets

Default HR zones were manually set.
Specific (HR, pace, power) zones are set by default
… well … what a pun

I usually use HR zones as intensity target for “multisport” or walking/trekking and it always works as expected.
This is the first time I try to use the pace target when switch to running (in multisport)