Altitude incorrect while hiking

[Łukasz Szmigiel]

@Sergei-Ladeishchikov did you manually set elevation prior to the hike?

[freeheeler]

@Łukasz-Szmigiel
that’s not necessary but doesn’t effect either

[Łukasz Szmigiel]

@freeheeler I’ve read somewhere around the forum that if you set elevation manually prior to the workout it can disable fused alti for some time.

[freeheeler]

@Łukasz-Szmigiel
yes that was true until a date we can not tell anymore because it’s unknown
I did a test recently and it was confirmed by others. you can do what you want and when you want with manual calibration, FusedAlti will correct it anyway if necessary

[Łukasz Szmigiel]

@freeheeler cool, didn’t know about it, thanks.

[Sergei Ladeishchikov]

@Łukasz-Szmigiel I did not set the height, the FusedAlti had to set it.

[Sergei Ladeishchikov]

@babychai All the maps show the same height - 3450 m. Either my FusedAlti was blocked at the beginning of the trip, it was blocked due to and did not work during the trip, or FusedAlti did not work at all. 1/3 of the trip was forest, the rest mountains with open space.

[sartoric]

@Sergei-Ladeishchikov
Was the track ok ? Maybe there was some GPS reception issue

[Sergei Ladeishchikov]

@sartoric Yes, the track was ok, total ascent was correct, too. I compared with this route.

[Dimitrios Kanellopoulos]

did you go into water?

this is a huge difference

[Sergei Ladeishchikov]

@Dimitrios-Kanellopoulos I did not go into the water, and there was no rain.

[Egika]

@Sergei-Ladeishchikov I understand the other device was showing even lower altitude? That means with even bigger error?
Maybe this is a mapping problem and the actual GPS altitude is lower than on the sign post?

[Sergei Ladeishchikov]

@Egika another device (garmin) showed 3425 m. There were several peaks on my route, and everywhere there was a rather large difference down.

[Egika]

@Sergei-Ladeishchikov I am with one of the first replies: Let’s find out, if this was a one-time glitch out of whatever reason or if it persists.
What we can confirm is, tha FusedAlti is supposed to work also in Endurance or Custom battery modes.

[Sergei Ladeishchikov]

How often does Alti need to calibrate altitude? at the start of the activity? during activity?

[Egika]

@Sergei-Ladeishchikov as stated before: It tries to calibrate during the beginning of the activity. It usually takes 12-15mins which will then correct the recorded altitude backwards from the start.
Right now I am not sure if the watch will try again if it fails after the first 15min…

[Łukasz Szmigiel]

@Egika what about sudden pressure drop due to storm happening i.e. 1+ hours after the start of activity? Won’t FusedAlti try to correct it after the initial calibration?

[isazi]

@Łukasz-Szmigiel fusedalti works during the whole activity.

[Sergei Ladeishchikov]

@isazi what can block the work of FusedAlti? or could it be a glitch? Does it make sense in such a case to send logs to check the work of FusedAlti?

[isazi]

@Sergei-Ladeishchikov not sure, maybe related to you using good and then switching to best GPS mode. Logs make sense if you can send them after the activity, it may be too late now.