Altitude

mikekoski490

@Iceman1 Fusealti does indeed help! It’s not perfect though, but waaay better than before it.

Egika

@Iceman1 can you specify of which difference we are talking about here? How many meters over how many hours of activity?

Iceman1

@Egika

Hi,
The worst I have seen is start at 0 meters and finish at 23 meters. 10,5km and 58 minutes.
23 meters is close to the correct elevation which I have found out to be ~30meters. This was before the latest update though. I would post a screenshot but i couldnt figure out how to attach it here.

Im mostly running where I live, and its flat here so not that big of a problem. But around here it could be for example start at 1 meter and finish at 8( which is correct elevation) at 40 minutes running. Not a big problem, Im just curious since looking at my friends activities on Strava (using garmin) they all seem to start and end at the same elevation

Brad_Olwin

@Iceman1 Strava often corrects for elevation.

JANTIKAINEN

All of a sudden my Race’s altitude reading (not in activity mode) went totally bonkers.
I’m in an apartment building something like +25-30 meters from the sea level. At first the watch showed correct altitude but today the reading is from -130 to-135 meters.
I wonder what’s going on with the sensor. I restarted the watch but it didn’t help.

mikekoski490

@JANTIKAINEN Check the barometer reading. If there is a super-fast or consequential change in atmos pressure, it can kick it out of baro/alti lock.

So if the baro suddenly changed upwards, it could make your alti readings go down (approx. 10m for every 1 hpa).

As much as there are locks and fused alti on these devices, good to manual check and update every once in awhile.

JANTIKAINEN

@mikekoski490 Thanks for the tip, I didn’t know that.
I did an automatic adjustment based on gps location and the watch corrected the altitude reading.
Since I restarted the watch the baro graph wasn’t anymore available as it looks like it behaves the same as the resources - history is swept. But if I remember correctly I recall there was a spike in the baro graph.

mikekoski490

@JANTIKAINEN Auto adjust is good if you dont know your alti for sure. If you know your current alti, manual is a bit faster and doesn’t drain the battery.

Ya, when you restart the watch, it zeroes the alti/baro graphs unfortunately.

Egika

@JANTIKAINEN depending on where you are based, bigger buildings often have some kind of ventilation control, that will have an influence on the pressure inside the building.
Have you checked if the altitude goes back to normal, wen you are outside?

Otherwise as others suggested, over the period of a few days, altitude can drift due to weather variations as well.

JANTIKAINEN

@Egika Thanks for your comment.
yes, I did try to go outside, but it didn’t change the altitude.
Here in Finland, in the most of the apartment buildings the ventilation system is still gravity based so I don’t think that’s the case here.
Anyway, things are back to normal