Sensors not reconnecting after pausing
-
@isazi thanks!
-
@Ze-Stuart I see the same issue
I wondered why my HR became erratic and if I look at ZoneSense it disconnected after just over an hour and did not reconnect!
Struggling to post a screenshot here, this may work
-
@Ze-Stuart i went in and checked one of my rides that was 2 hours and Zonesense was on (only S+ running at the time).
It looks like it did not drop off like yours did.
*The heart rate belt i had on hand to test with was a Coospo H808S with my Vertical and activity was mountain biking
-
@cumbrian-runner does the HR stre drop off at the same time, too? Trying to differentiate between loss of HRV data, and loss of all external HR data.
-
@Todd-Danielczyk said in Sensors not reconnecting after pausing:
@Ze-Stuart i went in and checked one of my rides that was 2 hours and Zonesense was on (only S+ running at the time).
It looks like it did not drop off like yours did.
Nope, looks like you maintained connectivity the whole time.
-
@Ze-Stuart Well it would have defaulted to wrist HR at that point of the disconnect.
As far as I know its impossible for a Polar H10 to present HR data but with no R-R interval data.
-
@cumbrian-runner does it switch to wrist in the event of loss of external? I don’t know (or perhaps, trust) that.
Agree with the paradigm, but again a lack of trust of the system the paradigm inhabits.
You should be able to copy/paste screenshots straight into the compose box.
-
@Ze-Stuart it does not switch to OHR if connection to external monitor is lost
-
@Ze-Stuart I have SV with the last version 2.37.34. I remeber that I have had the same problem with the version before.
-
@matteo_000 thanks!
