Clarification regarding raise-to-wake behavior

[leonidas]

Hi - updated to latest firmware 2.39.44 after owning the watch for 1 day - so unsure if this is how it is supposed to work.

Raise to wake shows me full watch face - but after some time of inactivity - raise to wake will show only time, without complications.

Is this how it is supposed to work?

I tried both settings in “Display” for raise-to-wake as display only or full Full wake mode - but I see no difference: after some inactivity, raise to wake brings just the bare analog or digital time.

[MRC01]

@leonidas Yes, the full display only stays on for 7-8 seconds and this is not configurable. This behavior has been reported before, with requests to make it configurable.

[Rayfox]

https://www.suunto.com/en-gb/Support/Product-support/suunto_race/suunto_race/settings/automatic-display-brightness/

[Stefano M64]

@leonidas said in Clarification regarding raise-to-wake behavior:

I tried both settings in “Display” for raise-to-wake as display only or full Full wake mode - but I see no difference

that’s strange:
in Full wake mode, the the Rise-to-wake turns the watch on (colorful watchface with complications) and it’s ready to be used,
in Display Only mode, the rise-to-wake just shows the time (black&white, no complications), then you need tu push a button in order to use all the other watch functions

[leonidas]

@Stefano-M64

Hi thanks - are you 100% sure about this? It does read that way in menus but its not how it works based on mine and other commenter experience.
If so - which FW are you on?
I will try to reset the watch and see if it helps

EDIT: You were right, thanks again. watch restart fixed the issue.