Blood oxygen
-
@Dimitrios-Kanellopoulos i have 2.46.14
Since last firmware update i notice every night Blood Oxygen is reporting around 92% before update it was usually 96-98%. And i am not able to measure manually. Tried many times in last days. Even tried soft reset. No change. Unable to measure manually.Update: after soft reset it is even worse, last night 88%, soon i will need oxygen mask
Update2: after rollback to 2.46.4 manually measures again, but results are low values. 88-93%, after 5th try i finally got 98% but since other 4 was around 90% it is hard to trust
Update3: two nights after rollback bloodoxygen worked and measured 96-98% rannge
-
i have the same problem. My Race 2 cannot measure the blood oxygen by manual.The software version is 2.48.16.
-
@Dimitrios-Kanellopoulos Same probleme. Low measurements and no manual possible. SW 2.48.16 app Android 6.4.7
Suunto Race 2 Titanium Trail
-
I had problems before but with 2.48.16 it works fine. Did you tried soft reset?
-
@Eddy-De-Backer unfortunately, i tried to soft reset but it did not work for me.
-
@S.Pichi the same for me
-
@Eddy-De-Backer Same issue no manual measures , soft reset didn’t help.
-
My Suunto Race 2 stopped measuring blood oxygen after updating to version 2.48.16. Manual measurements don’t work at all, and the nighttime readings are inaccurate. A soft reset didn’t help.
-
My watch too
-
@Dimitrios-Kanellopoulos when i try manually have consistently below 90% saturation with firmware 2.48.16 on 9Peak Pro, but nightly measurement are ok (98-100%)
