S9B - problem with battery modes
-
Until 0:21:44 is active Performance mode. Endurance mode is active from 0:21:44. But only until 0:27:13. Then Performance mode is active again. And again, from 0:30:21, is Endurance mode until the finish.
🔺Vertical All Black
ex:
Ambit2 Black
Ambit3 Peak Sapphire
Spartan Ultra Stealth Titanium
S9B All Black
Ocean All Black (for testing only)
>>> YouTube Channel <<< -
@Pavlas S9 automatically switches to 1s GPS fix when you switch to the navigation screen. Isn’t this the case?
-
As @inkognito said.
A little bit more detail:
- When you start an activity for the first 1-12minutes until when the altitude is calibrated the perfomance mode is used.
- When you switch to the navigation screen then performance is used.
Community Manager / Admin @Suunto
Creator of Quantified-Self.io
youtube.com/c/dimitrioskanellopoulos
https://instagram.com/dimitrioskanellopoulos
https://www.strava.com/athletes/7586105 -
@Dimitrios-Kanellopoulos
@inkognito
No, I didn’t use navigation.
Well, maybe the altitude was calibrated. But why did the Performance mode reactivate after another 6 minutes?
I have this problem whenever I want to use Endurance or Ultra.🔺Vertical All Black
ex:
Ambit2 Black
Ambit3 Peak Sapphire
Spartan Ultra Stealth Titanium
S9B All Black
Ocean All Black (for testing only)
>>> YouTube Channel <<< -
@Pavlas did you go to the breadcrumbs screen. ?
-
@Pavlas This is an extremely short time frame for either Endurance or Ultra modes, as @Dimitrios-Kanellopoulos stated, it may take time for the FusedAlti to activate. I typically don’t use Endurance for anything less than 20h and Ultra for anything around 48h long.
-
@Brad_Olwin This was just a test. In fact, I usually only use Performance mode. I just want to know if there’s a mistake in the watch.
@Dimitrios-Kanellopoulos
Do you mean a navigation screen without navigation? Yeah, I switch to it sometimes, but maybe for only 1-2 seconds. (to return to the first screen). Can it have an effect?🔺Vertical All Black
ex:
Ambit2 Black
Ambit3 Peak Sapphire
Spartan Ultra Stealth Titanium
S9B All Black
Ocean All Black (for testing only)
>>> YouTube Channel <<< -
@Pavlas yeah that turns the GPS to best in order to show you your current location in relation to your track.
Remember, Ultra + Endurance modes turn on the GPS every 1minute or 5 minutes (ULTRA).
So when you go to that screen it will enable the GPS, then when you leave, turn it off after a few and back on again.
If you want to avoid that while toggling screens , you can turn “nagivation off” from breadcrumbs, and that should not happen then.
Community Manager / Admin @Suunto
Creator of Quantified-Self.io
youtube.com/c/dimitrioskanellopoulos
https://instagram.com/dimitrioskanellopoulos
https://www.strava.com/athletes/7586105 -
@Dimitrios-Kanellopoulos Okay, I’ll try it!
Thanks a lot! -
@Dimitrios-Kanellopoulos Hi, I tried it and it works!
BTW Suunto support wanted me to send the watch for service. In the end, it was my fault.
Thank you!🔺Vertical All Black
ex:
Ambit2 Black
Ambit3 Peak Sapphire
Spartan Ultra Stealth Titanium
S9B All Black
Ocean All Black (for testing only)
>>> YouTube Channel <<< -
@Pavlas said in S9B - problem with battery modes:
@Dimitrios-Kanellopoulos Hi, I tried it and it works!
BTW Suunto support wanted me to send the watch for service. In the end, it was my fault.
Thank you!I tested my battery the last couple of weekends in Endurance mode for 3.5h to 6h runs. GPS only + smartsensor +Route loaded no SuuntoPlus my battery estimate on the watch was 50h and on QS was 45h. So, according to my tests all is working as expected.
-
@Brad_Olwin just a couple of 3.5 to 6 hour runs, no big deal
-
@stromdiddily said in S9B - problem with battery modes:
@Brad_Olwin just a couple of 3.5 to 6 hour runs, no big deal
… sprint training …
-
@stromdiddily @johann-fuehrer Yes, my average weekend runs in the winter are 4-7h, shorter than my weekend training in the summer:). Once SkiMo gets going full swing here, I’ll have longer days…
