Software update 2.16.26 June 10th 2021
-
@tomas5 I’m not sure about backlight but certainly GPS + Galileo estimates pre-workout are way too optimistic. Either this or battery degradation is slowly crawling in on my S5. Anyhow there’s no way I’m getting 20 hours of battery time in performance when fully charged with GPS + Galileo as suggested by the UI (21 I think at 97%).
-
@łukasz-szmigiel well, i have S5 around 4 months, so I am sure it is not battery degradation, it is since last firmware update. It is not much but it is noticeable.
-
@inkognito Same setup and problem here! 🤬
And I need my S9 baro in one week for a multiday and night trailrun. Without backlight while recording an activity!
I was always happy with multiple Suunto products, but now its painful. The other bad experience with the service is my ‘jumping’ barometer sensor. I send the watch to the Soonto repaircenter and they did only a firmware update (it was in the garantie time)
-
@peter-tönz I mean the problem with the missing backlight with a custom power mode!
-
I know I posted it in a thread, but please forward it to Suunto that they might check their GPS tracking “code”
Thanks
-
@theguyfromthesummit btw I checked my mountain activities and I seem to get similar results to what you have on the right.
-
@dmytro ok, strange. Everyone of my friends using a Suunto has the same problem as I have.
-
@theguyfromthesummit ¯_(ツ)_/¯
On another note I seem to remember (but maybe just imagining) that suunto tweaked it’s smoothing algo to prevent cutting corners etc, thus making it a little more susceptible to noise which seems to be impacting your trainings. -
@dmytro this might be the reason.
checking some cycling tracks (10-60km/h) and it is really smooths.
Maybe I just have to run faster
-
@theguyfromthesummit I hike, not run, so dunno. But I wear my watch on the right hand.
But of course good luck with your 60kmh runs! -
So I just sent the logs to Suunto (19th Aug 12:30 CET). The s9b crashed during activity (black screen no response from button presses.). That’s 2nd crash (one in one out of activity) in less than 4 months (it looks a lot when compared to 0 in 2y on the f6x doesn’t it?)
Details: Snap to route, HR Belt, Suunto plus: Strava relative. Didn’t restart (or continue) the activity. -
S9 (non-baro): Not sure if this wasn’t reported before, but in all the previous firmwares the activity icon in the watch logbook was grey before it was synced and turned to appropriate colour (yellow for runs, green for walks etc.) after the sync. Now the icon remains grey even after the sync. Or is it just me?
Perhaps the lucky Suunto field testers could check whether this was/wasn’t already solved in the “autumn firmware” we all hope for SV: fingers crossed :D
S9 (non-baro): died after 2 months, replaced, holding strong since 03/20
Spartan Trainer: casing broke after 23 months, repaired, lost watertightness 5 months later, died
Despite some pretty bad luck, I still love Suunto! -
@inkognito my icons are colored in 2.16.26 firmware, but I do not have a non-baro S9 to test.
-
@inkognito all icons of the (synced) activities in my activity list/logbook on the watch are coloured (Non-Baro 9, SW 2.16.26)
-
-
@inkognito I have all icons gray except the corrupted one is yellow (running)
-
Hmm
Something new is coming?SUUNTO NEW WATCHFACES
https://www.youtube.com/watch?v=aXecSKxNc8QSUUNTO MEDIA CONTROLS
https://www.youtube.com/watch?v=dpfK1bLtIjsSUUNTO 9 PEAK
NEW ALTI ALGO
https://www.youtube.com/watch?v=1E6knJn5MlESuunto Race
Polar H10
Iphone 14 Pro
Suunto 9 Baro [sold] -
@bogdan1921 wow, media control was unexpected!
-
@bogdan1921 the update is out btw
-
@dmytro Seem`s like an awesome update!!
I did the hard reset recently and it this didn’t change. Still, even the synced activities have grey icons.
