Software Update 2.40.44 (2025 Q1 Hotfix)
-
@pavel.samokha said in Software Update 2.40.44 Beta (2025 Q1 Hotfix):
@cosme.costa Just to clarify:
S+ WF updates should not reset your WF settings.
In my experience, with all the firmware updates since the introduction S+ watchfaces, the watchface is reseted after some hours out of the blue, then you need to configure it again and no issues anymore until next update. I do not know if the watchfaces update in s+ have happened at the same time or some hours later after the firmware update and for that reason I relate them.
-
@Artus-Diver yes we want correctly swimming breastroke because watch no counts meters.
-
S9PP, it works
-
shame that TSB complication not updating unless an activity is started is not in this bugfix release.
-
@Artus-Diver Sorry, no changes in this release as far as I know. There should be some improvements in Q2, but I cannot say if they solve all the issues.
-
Installed with no issues. Will run later today.
-
Installed successfully on Race S.
-
@James-Eastwood said in Software Update 2.40.44 Beta (2025 Q1 Hotfix):
@Łukasz-Szmigiel shame that TSB complication not updating unless an activity is started is not in this bugfix release.
I agree, I would like to see this problem resolved. I know that there are worse bugs and there is a workaround for this issue, but even there I would welcome it if it was resolved.
-
Still no updates for mye Race
Suunto Ambit 3
Suunto Spartan Ultra
Suunto Race Ti -
@Marius-Jacobsen-Eggerud It’s not automatic - this is a beta - use the link above from your mobile device
-
@Marius-Jacobsen-Eggerud why? you can download the beta for SR?
-
@SuperFlo75 my fault. Didn’t red the full post
-
Downloaded. Everything went fine!
-
Installed. WF hasn’t changed after the update. It’s a progress
-
S9PP updated. WF same as before the update, so looking good from this point of view.
-
@pavel.samokha How many days between beta release and official release ?
-
@Antoine if no issues detected, then likely just a few
-
@pavel.samokha The custom battery mode issue is still present in this release
-
Sleep, resources and HR over night tracked without issues. However, yesterday after software update resources widget on the watch got stuck, HR widget was OK. After 12 s reset the issue was resolved. Also alarm clock worked OK.
-
I guess no fix for the WIFI turning on issue?
