problems with my S9B
-
@Luis-Duarte There are two issues that could be causing this. First, if the holes on the S9B are being covered by skin or something else that blocks the baro sensor. I can have this problem if I wear on my right hand, when I flex my wrist it covers the holes and I get wrong readings ±D. Second is wind, if it is very windy and directly hits the baro sensor the ±D can be wrong.
-
some days I caught wind, but it happened on sunny days and good weather.
I can try to wear it on my right wrist.
I did factory reset again.
if covering the watch with the waterproof can be a problem?
Thank you for help -
-
-
@Luis-Duarte can you try to have your watch under your sleeve and see if anything happen? Or switch position of S9 and A3 next time (so that the baro opening will be blocked for the A3 and not for the S9)?
-
@Luis-Duarte
Are you syncing your S9b activities to SuuntoApp with Android smartphone? -
@Mff73 yes
-
@isazi ok thanks
I’m go to try it -
@Luis-Duarte said in problems with my S9B:
@Mff73 yes
So.
there are raw data files you may use and import them in QS, maybe you could see something interesting (registered altitude vs GPS altitude for example)
See here where to find this file.
https://forum.suunto.com/post/33052 -
As I see. You use a rain jacket for you’re workout.
Sadly the hole of barometer sensor of S9 is not at the same place of A3 Peak.
I think you’re jacket came to touch the S9 hole during you’re run.
Try to use S9 over the jacket. Or on the left wrist but try to don’t touch it with your hand. -
The problem is here
The sensor, comes into contact with the jacket and pushes the sensor.
-
I believe that @Luis-Duarte has the watch since christmas maybe he has runs without jacket and that this issue may be recurrent.
If S9B is so sensitive to jackets how runners do? -
@Mff73 thanks
-
-
@Dimitrios-Kanellopoulos I don’t remember training without the raincoat but it is possible that it happened.
I will have attention in the future…
since March I have not run on the mountain again.
now I came back and the problem happened again
But if that is the problem it is a big mistake for a top suunto watch.
I hope to solve the problem
thank you all -
Running_2020-01-24T08_08_12.fit
I think this was the first with problems
-
@Luis-Duarte said in problems with my S9B:
Running_2020-01-24T08_08_12.fit
I think this was the first with problems
In this one, your altitude registered after 10km is really noisy, while quite nice for first 10km.
Something may effectively have affected baro sensor (sleeve, wind, water, wrist movement,…).
-
@Mff73 said in problems with my S9B:
@Luis-Duarte said in problems with my S9B:
Running_2020-01-24T08_08_12.fit
I think this was the first with problems
In this one, your altitude registered after 10km is really noisy, while quite nice for first 10km.
Something may effectively have affected baro sensor (sleeve, wind, water, wrist movement,…).@Mff73 is correct, the noisy data are where the wrong data were recorded. This occurs as I stated early in the thread because of skin or garments blocking/pushing against the sensor. The wind has to be very strong for this to happen. There is likely nothing wrong with the watch.
-
I will test the watch again.
I will do what you said
thank you all
I’ll tell you how it went -
@André-Faria said in problems with my S9B:
I believe that @Luis-Duarte has the watch since christmas maybe he has runs without jacket and that this issue may be recurrent.
If S9B is so sensitive to jackets how runners do?You put the watch over the jacket, I least I do that way, of course you can’t use OHR, you need a strap if you want HR readings.
