Not Vibrating & option limited to just 'On-Off'.
-
@surfboomerang said in Not Vibrating & option limited to just 'On-Off'.:
@Sergei-Ladeishchikov yes, same for me. The power save option has no effect on the vibration when the watch is below 10% (or 12%in my case). Just charging the watch fixes it.
Do I need to send logs if this problem occurs again?
-
@Sergei-Ladeishchikov I can ask if this is expected or not, but during summer I’m not sure an answer will be provided.
Watch: Suunto Vertical Ti
Blog: isazi's home
-
@isazi The most important thing is that Suunto is aware of the problem and can fix it with future updates)
-
@Sergei-Ladeishchikov, @isazi isazi, @surfboomerang
Thanks for you suggestions but vibration still didn’t work after fully charging and also after a hard reset.
‘Vibration’ option under Settings-General-Tones-General, only shows a ‘on-off’ option, NOT ‘‘Buttons-off’, All-off’, ‘All-on’. Could this be a firmware version issue? Do you think it’ll help if I can roll back to a previous version?
Watch: Peak 9
-
Reported as a bug
Watch: Suunto Vertical Ti
Blog: isazi's home
-
@isazi hi! Do you think this will be followed up by someone?
No vibration is bothering me a lot. -
The issue that vibration is disabled when the watch battery is below 10% is being investigated.
-
@isazi the issue is actually: No vibration at all, even when 100% charged.
-
@Ashish-Bhattarai do you get a short vibration when you reboot the watch? It could be hardware related.
-
@surfboomerang when I power off and bring it back on, it did vibrate for a short while!
-
@Ashish-Bhattarai Great, hardware seems to work then.
Just make sure you didn’t enabled the “power saver” option and “Do not disturb” option".
