@isazi said in Translation Bugs (Turkish): I’ll let the developers know

Yes, it happened on one route I created in the app, and one that I recorded and saved as a route. the climb page that shows climb profile of the route and vertical left in the route works fine. When I scroll to the climb training app it is blank. This only matters to me because I like to know grade of climb.

@timecode Yes, that is what happened automatically at the tail end of the factory reset. I understand, the scrolling complications were ditched for the static. When you have only touched them a few minutes before they disappeared (after the update) hard to “miss” but I did not know if it had something to do with a setting I could not locate. Thanks for clarifying.

@far-blue Boom! It was under Training setting, thank you for pointing me in the right direction! That was under 10 minutes from my initial question, great community! Out for a run now able to control my podcasts from my wrist.

Good day! We only need a tide watch as the old casio’s, you put the high and low tide and calculets for itself Cheers

@Stefano-M64 and actually every current smartphone has this option I think.

@Egika hey, I didn’t try. The sensor is correctly calibrated to the wheel size. If it was a calibration issue, the speed would be consistently wrong, not inconsistently wrong, eg if I was going 25km/h, and the size was set too big, it would show 30km/h, instead of 25 25 25 7 5 3 7 12 25 25 25. Edit: it makes me think of the power meter issue reported on the main firmware update thread, with dropouts: if the Bluetooth connection to the sensor dropped, and the watch wasn’t receiving the correct revolution data form it, the speed would be incorrect.

@Milan-Šádek thanks, tomorrow they gonna pick up from home to send it to the repair center

@GiPFELKiND I am on iOS and it works fine, The watch must not be syncing and have a green check to create custom sport mode. When you open the app it may immediately start syncing so be patient.

@Naiden no… your buttons are stiff? compared to which models buttons?

@Valdis-Liberts this is already discussed in another thread https://forum.suunto.com/post/120467

@markman8 @markman8 said in Last pool length memory recall: Right now it goes back to 25m for metric settings. Sorry for the wrong info. It did go back first time that I set it to 20m for some reason. It did not happen from there onwards. It correctly keeps the last session’s pool length that it was set.

I agree. While on a night ride I discovered the backlight options were either on or off!! Suunto, please introduce a graduated backlight with maybe 3 or 4 brightness settings. This means the watch face could be seen at night, but not put too much strain on the battery.

@BrunoH at least the bezel size isn’t the only problem anymore

@greku I agree that could be an useful feature, but at least on my garmin you edit the name after. But if the suunto vertical is like old devices which only allows one sensor of the same type then there is little point on editing the name after (I guess).

@Rokelly are you in contact with support already? If not, send me the email you use for Suunto App and the time you sent the logs in a PM

@Ultrarunner you can upload routes in GPX, or create them in the app, or send them from Strava, Komoot, etc. You can follow TP workouts, the watch beeps and vibrates at the beginning of a step. Stryd works, also the native wrist power, and you can use power workouts (natively, this is one thing that Suunto supported much earlier than Garmin).

@GiPFELKiND and recovering is when my heart rate is over 90 bpm!? Suunto what is the Problem… I dont understand this measurement… Please explain how this should work… My rest hr is setting on 58… How could it be that i am recovering on this 90 HF