SuuntoApp - Loop Pace - I can not make it work...
-
I don’t think it’s likely to be a problem specific to S9 Peak Pro or the firmware version. What kind of speed were you running, and what were your exercise settings, for example navigation and battery mode settings? What kind of loop were you running?
-
I used custom cycling mode with the following settings :
- Battery mode : custom (best accurancy/ touch screen ON)
- Pairing : Power device / HR belt
- S+ : Multiple -> 2 S+ apps (Power and speed loop)
- Navigation
-
@Wilson75 OK, thank you. Which Navigation setting did you use? Using two loop apps at the same time may not produce good results, at least they will both create a separate lap when loop ends. I’m not sure if using two loop apps at the same time also affects loop detection, I’ll try to test it.
-
@Raimo-Järvi I walked today with custom sport mode.
S+ : 1 app used - loop pace
Battery mode : custom - best GPS / touch screen activated
Navigation : breadcrumbAnd lap didn’t work…
Strenge
-
@mklbhm are you able to use S+ Loop?
I tried again after the last firmware (Q2) and it still does not work… -
@Wilson75 can you describe again how you use it?
-
@isazi
I use walk activity (not custom) and suunto plus Loop Pace.
I simply launch my activity.
I tried once without pressing the lap button and got no loop detection.
I also tried pressing the lap button to set a new location for my loop and no loop detection either. -
@Wilson75 did you press the lap button on any screen, or the app screen? It only works in the app screen as far as I know.
-
@isazi Yes in the app screen. I also get the message from the app screen that I set a new location for the loop.
-
@Wilson75 can you try with a running activity?
-
@isazi I tried with run and cycling. I can try again and I will let you know.
-
@Wilson75 I use the app every week, always worked for me, I do not know what could be wrong
