SuuntoApp - Loop Pace - I can not make it work...
-
I used custom cycling mode with the following settings :
- Battery mode : custom (best accurancy/ touch screen ON)
- Pairing : Power device / HR belt
- S+ : Multiple -> 2 S+ apps (Power and speed loop)
- Navigation
-
@Wilson75 OK, thank you. Which Navigation setting did you use? Using two loop apps at the same time may not produce good results, at least they will both create a separate lap when loop ends. I’m not sure if using two loop apps at the same time also affects loop detection, I’ll try to test it.
-
@Raimo-Järvi I walked today with custom sport mode.
S+ : 1 app used - loop pace
Battery mode : custom - best GPS / touch screen activated
Navigation : breadcrumbAnd lap didn’t work…
Strenge
-
@mklbhm are you able to use S+ Loop?
I tried again after the last firmware (Q2) and it still does not work… -
@Wilson75 can you describe again how you use it?
-
@isazi
I use walk activity (not custom) and suunto plus Loop Pace.
I simply launch my activity.
I tried once without pressing the lap button and got no loop detection.
I also tried pressing the lap button to set a new location for my loop and no loop detection either. -
@Wilson75 did you press the lap button on any screen, or the app screen? It only works in the app screen as far as I know.
-
@isazi Yes in the app screen. I also get the message from the app screen that I set a new location for the loop.
-
@Wilson75 can you try with a running activity?
-
@isazi I tried with run and cycling. I can try again and I will let you know.
-
@Wilson75 I use the app every week, always worked for me, I do not know what could be wrong
