Suunto 2.50.26 – Q4 2025 Release Notes

[sustah]

Thanks, I will try this workaround… but I did not have this problem until 2.50.26 update… and I did not change anything in app.

[Lorenzo Pintore]

@Dieter1960 It may be cause by the cold: temperatures were around 3°C during that run. I’ll try on the treadmill to verify this.

[Theo Lakerveld]

@Lorenzo-Pintore, I did a short run and the registered HR was much more compliant with my feelings than previously. I’ll test during the weekend and compare with a belt during an indoor cycling session.

[2b2bff]

@Lorenzo-Pintore said in Suunto 2.50.26 – Q4 2025 Release Notes:

Have any of you already experienced the new OHR algorithm?

I know it is lengthy, but you should actually read this thread instead of only posting…

I posted twice…
https://forum.suunto.com/post/182613
https://forum.suunto.com/post/182856

Which watch did you use?

[Tami999]

I dont pay much attention for calories burn, especially from a watch, but yesterday (with chest strap) and tried today without (only watch OHR), I had 20% less calories burn than usually during run.

[BRogers80]

@Mads-Hintz-Madsen
Same for me. Never had any problems with ressources. Now I always relax.
I had this night a very high hrv measured. Maybe the new algo measures hrv a little bit different. Aren´t ressources also based on hrv intraday?

Ressources was for my always a good indicator how I recover at night. Much better than any sleep score. Now it is uselss.

[VoiGAS]

@Lorenzo-Pintore Tried it today with the Race S for an indoor training / cycling session. It worked perfect (compared it to the Vertical with HR belt).
Outdoor Running in cold temperatures I couldn’t test so far

[VoiGAS]

Bike sensor still shows nothing . I was hoping for a Bugfix release, instead there are new features.

[sky-runner]

@Dimitrios-Kanellopoulos said in Suunto 2.50.26 – Q4 2025 Release Notes:

@sky-runner we made nice changes for you I think I need a seperate post from you

I need to try to repeat some of the previous runs on rolling terrain to see what difference in ascent / descent it makes. I haven’t had a chance yet.

@Dimitrios-Kanellopoulos, so I far I have tried repeating one previous run on a rolling terrain - compared to the previous firmware version both distance and total ascent ended up being exactly the same. But at least I didn’t have to raise my arm at the top of each small climb, so perhaps that is an improvement!

However I wanted to use this chance to remind about two other bugs / issues:

[1] The estimated ascent given by Suunto app for the route is pathetically wrong. Strava calculated 441 ft elevation gain when I created a route from a previous run. In Suunto app the same route’s ascent shows as 280 ft. The actual elevation gain after running it is 535 ft, so almost 2x difference.

I looked at climb guidance during the run and every single climb showed up with less ascent than actual. For example, in one case climb guidance showed a 33 ft ascent. By the end, when the ascent was replaced by a flat section in the climb guidance, I had already climbed 72 ft and in fact there was still probably another 10 ft of climbing in front of me, but the watch had already switched to a flat section. And that is what I see consistently when running on rolling terrain. All moderate ascents and descents are almost always inaccurate and fairly short of the actual elevation changes.

[2] Navigation improvements such as larger arrows are claimed at the top of the thread. I am not sure what that is supposed to mean, but one annoying bug that I’ve reported over a year ago is still present:

As you can see the light blue navigation errors are rendered behind the red breadcrumbs tracks, and in some situations that is disorienting. I’ve seen multiple cases where I am at a junction that I’ve already gone through a couple of times with two or more possible ways in the navigation route and it is nearly impossible to tell which way to go because the light blue arrow is behind and nearly invisible. I can probably find some sceenshots of this issue that I’ve made earlier.

Is the development team aware of this issue and why such an obvious issue isn’t being addressed? It would be quite reasonable to always render the light blue arrows on top.

[DrSilverthorn]

@sky-runner I too have noticed that the SA ascent numbers are very wrong. They appear to be too low.

[GiPFELKiND]

@DrSilverthorn here the ascent numbers are to high. Walking at sealevel and suunto says 222m positive Elevation, i never had this before

[Dimitrios Kanellopoulos]

@GiPFELKiND I need this file please. Did you record with the app or watch ?

[borgelkranz]

@VoiGAS Same Here

[GiPFELKiND]

@Dimitrios-Kanellopoulos with my Vertical2

[duffman19]

@DrSilverthorn said in Suunto 2.50.26 – Q4 2025 Release Notes:

@sky-runner I too have noticed that the SA ascent numbers are very wrong. They appear to be too low.

It seems that the digital elevation model Suunto is using is better in some places than others. It looks like it’s pretty accurate for users in Europe, but less so for those of us in North America. Most of the routes I’ve planned in SA have very jagged elevation profiles suggesting that there are very few elevation reference points in my area. Not exactly sure which service Suunto is using (I’m assuming they are paying a third party for the data), but it makes sense they would prioritize Europe first. Although I’m also not sure why they can’t get a globally accurate model.

[Dimitrios Kanellopoulos]

@GiPFELKiND are the stats on strava ok ?
if not there, then you got a dirty sesnor

[surfboomerang]

@Dimitrios-Kanellopoulos for reference…
I did an almost similar round of running before and after the firmware update of my SV1.
The route is totally flat except for one tunnel. This explains the small dips in the altitude graph.

Before the firmware update: ascent 0m, descent 0m

After the firmware update: ascent: 4m, descent 19m

I live 1m below sea level which was nicely recorded before the firmware update. After the firmware I ended the run with -18m

[GiPFELKiND]

@Dimitrios-Kanellopoulos same here

[jussim]

Great to see that it is now possible to select ZoneSense for indoor rowing.

And even better that now the multiple heart rate monitors (optical and traditional belts) are handled smoothly.

Not to forget that an older model such as 9PP would even receive and upgrade. Good job, Suunto.

[Dimitrios Kanellopoulos]

for any person getting too much ascent / descent on flat routes please open a new thread and post there are relevant info and files