Suunto app Forum Suunto Community Forum
    • Recent
    • Tags
    • Popular
    • Users
    • Groups
    • Register
    • Login

    Suunto 5

    Scheduled Pinned Locked Moved Suunto 5
    240 Posts 51 Posters 23.1k Views
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • sartoricS Offline
      sartoric Moderator @Dušan Ković
      last edited by sartoric

      @Dušan-Ković said in Suunto 5:

      @whl_89 One of my friends wants to buy S5, so I’m searching for possible problems with watch. Maybe this is one of the problems with S5. Have you tried GPS, GPS+GLONASS or GPS + GALILEO on the same route with S5?

      My 2 cents … if he’s some kind of mountaineer , tell him to go for a baro watch otherwise GPS only is ok.

      SVTS - 2.40.38
      SSSWHR BARO Amber - 2.8.32
      Samsung A5 2016 - Android 7.0
      Samsung A33 2022 - Android 14 - One UI 6.1
      Suunto App Android 5.2.5 beta
      Suunto App IOs 2.45.0 (19123) beta on MBP M1

      Dušan KovićD 1 Reply Last reply Reply Quote 1
      • Dušan KovićD Offline
        Dušan Ković @sartoric
        last edited by Dušan Ković

        @sartoric @Armin-S @whl_89 Thanks to all. I’ll send him the link to this thread 🙂

        SR
        SA latest beta
        Polar Verity Sense
        Pixel 6

        1 Reply Last reply Reply Quote 0
        • Brad_OlwinB Offline
          Brad_Olwin Moderator @whl_89
          last edited by Brad_Olwin

          @whl_89 said in Suunto 5:

          I bought my girlfriend a s5 and after a fews runs i am a bit confused because the ascent recorded by the watch is about 50% of the real ascent. I use the ssu. I know s5 has no baro but at least it should record the GPS ascent which is about the same i her from the ssu. Is this a known issue?

          I have done a lot of runs with both the S5 and S9 together, most of the time on the same arm. The S5 is always short in altitude, I mentioned this much earlier in the thread. If you care a lot about real time vertical it is not the right watch. However, I rarely see 50%, most of the time my differences are below 20%. The worst scenario for the S5 are lots of small hills as it does not record a change unless 7m. On big climbs it is much better. If you like I can post some of my SkiMo runs or runs with at least 500m altitude change. I do think that GSP+Galileo gives better altitude readings on the S5 but I have not thoroughly analyzed this yet. Third party sites (Strava, etc) will correct the altitude so in the end it isn’t that big a deal in my opinion.
          I still think the S5 is a great watch and most of the time I use it for my weekday runs and just let the 3rd party apps correct the altitude. The SSU and S5 should be similar for ascent. Make sure AGPS is current and I would use GPS+Galileo.

          Vector/T6c/Ambit 3 Peak/S5 Copper/S3/S7 Ti/S9 baro Ti/S9P Ti/S9PP Ti/Vertical Ti/Race Ti/RaceS/Ocean/Wing

          Dušan KovićD 1 Reply Last reply Reply Quote 3
          • Dušan KovićD Offline
            Dušan Ković @Brad_Olwin
            last edited by

            @Brad_Olwin maybe suunto app should add altitude correction as one of the features. So users can choose to see corrected altitude and original as watch recorded

            SR
            SA latest beta
            Polar Verity Sense
            Pixel 6

            Brad_OlwinB 1 Reply Last reply Reply Quote 2
            • Brad_OlwinB Offline
              Brad_Olwin Moderator @Dušan Ković
              last edited by

              @Dušan-Ković Probably not a bad idea but… if you have more than one watch as do I, I would want the setting toggled. Better yet, the app could detect you have a watch with no barometer and automatically correct. Maybe this should be added as a feature suggestion?

              Vector/T6c/Ambit 3 Peak/S5 Copper/S3/S7 Ti/S9 baro Ti/S9P Ti/S9PP Ti/Vertical Ti/Race Ti/RaceS/Ocean/Wing

              Dušan KovićD 1 Reply Last reply Reply Quote 0
              • Dušan KovićD Offline
                Dušan Ković @Brad_Olwin
                last edited by

                @Brad_Olwin I don’t have two watches, I only have S9B, but elevation correction would be good for users with non Baro watches. It should be implemented to SA. Also, users with Baro watches could check if altitudes are correct.

                SR
                SA latest beta
                Polar Verity Sense
                Pixel 6

                Brad_OlwinB 1 Reply Last reply Reply Quote 0
                • Brad_OlwinB Offline
                  Brad_Olwin Moderator @Dušan Ković
                  last edited by

                  @Dušan-Ković said in Suunto 5:

                  @Brad_Olwin I don’t have two watches, I only have S9B, but elevation correction would be good for users with non Baro watches. It should be implemented to SA. Also, users with Baro watches could check if altitudes are correct.

                  The correction for Altitude is less precise than the barometric watches, I have checked this many times on Training Peaks. It depends on the filters are algorithms used.

                  Vector/T6c/Ambit 3 Peak/S5 Copper/S3/S7 Ti/S9 baro Ti/S9P Ti/S9PP Ti/Vertical Ti/Race Ti/RaceS/Ocean/Wing

                  1 Reply Last reply Reply Quote 1
                  • D Online
                    dulko79
                    last edited by

                    One little remark regarding the strap. During sport activity the watch should be worn 2 fingers above the wrist bone to get good HR reading. For some users due to this position the strap could be too short or on the limit, therefore slight increase of strap length could be useful. ☺

                    App: beta
                    Phone: Iphone
                    iOS

                    1 Reply Last reply Reply Quote 0
                    • vicarokaV Offline
                      vicaroka
                      last edited by

                      Hi!

                      I am a new Suunto 5 user, and the watch keeps restarting and freezing after some minutes. The down arrow is displayed, and after a hard reset, the issue repeats after some minutes. Did software update to latest, not using movescount (only Suunto app).
                      Any suggestions?

                      Many thanks.
                      KR

                      sartoricS 1 Reply Last reply Reply Quote 0
                      • sartoricS Offline
                        sartoric Moderator @vicaroka
                        last edited by sartoric

                        @vicaroka said in Suunto 5:

                        The down arrow is displayed, and after a hard reset, the issue repeats after some minutes

                        What do you mean for hard reset, factory reset + re-flashing the FW ?

                        Maybe it’s a defective unit. Contact support via email

                        SVTS - 2.40.38
                        SSSWHR BARO Amber - 2.8.32
                        Samsung A5 2016 - Android 7.0
                        Samsung A33 2022 - Android 14 - One UI 6.1
                        Suunto App Android 5.2.5 beta
                        Suunto App IOs 2.45.0 (19123) beta on MBP M1

                        vicarokaV 1 Reply Last reply Reply Quote 0
                        • vicarokaV Offline
                          vicaroka
                          last edited by

                          This post is deleted!
                          1 Reply Last reply Reply Quote 0
                          • vicarokaV Offline
                            vicaroka @sartoric
                            last edited by

                            @sartoric
                            Yep, soft-reset: upper right+left button for 12 sec
                            hard-reset: from Suntoolink to flash firmware again.

                            sartoricS Brad_OlwinB 2 Replies Last reply Reply Quote 1
                            • sartoricS Offline
                              sartoric Moderator @vicaroka
                              last edited by

                              @vicaroka
                              So the best option is to contact support

                              SVTS - 2.40.38
                              SSSWHR BARO Amber - 2.8.32
                              Samsung A5 2016 - Android 7.0
                              Samsung A33 2022 - Android 14 - One UI 6.1
                              Suunto App Android 5.2.5 beta
                              Suunto App IOs 2.45.0 (19123) beta on MBP M1

                              1 Reply Last reply Reply Quote 0
                              • Brad_OlwinB Offline
                                Brad_Olwin Moderator @vicaroka
                                last edited by

                                @vicaroka This should not occur. If you have done a full factory reset you should contact support. The S5 is not recognized by MC so that doesn’t matter.

                                Vector/T6c/Ambit 3 Peak/S5 Copper/S3/S7 Ti/S9 baro Ti/S9P Ti/S9PP Ti/Vertical Ti/Race Ti/RaceS/Ocean/Wing

                                1 Reply Last reply Reply Quote 0
                                • Stanley PonS Offline
                                  Stanley Pon @Mi_chael
                                  last edited by

                                  This post is deleted!
                                  1 Reply Last reply Reply Quote 0
                                  • First post
                                    Last post

                                  Suunto Terms | Privacy Policy