[Watch] Instant HR on new firmware 2.0.40 (spartan)

[SlaSh]

@oeagleo seems HR sensor resets itself to 72 as starting point. I have scosche rhythm which utilize valancell sensor as well and it acts the same until hr is locked it shows 72.

[suzzlo]

Same here, bug or are we all robots with same fw?

[SlaSh]

@suzzlo bug which wasn’t present with 10min graph in old FW.

[Dimitrios Kanellopoulos]

Definitely, a bug and I think it’s confirmed. After a few seconds it should be ok

[sartoric]

well … about the 10 min graph …

[SlaSh]

@sartoric don’t put salt, we know where we left last time

[Dimitrios Kanellopoulos]

@slash point taken

[jaguarana]

@dimitrios-kanellopoulos same here. Sometimes it needs over a minute. Definitly a bug.

[jthomi]

Moved to lounge.

[Barfoot]

Yeah not much faith in the instant HR. Shows 72 or doesn’t change if I increase activity. Stays the same until it times out and goes back to the main watch face. WHR seems to be fine during runs/excerise. Actually better than before the update. Any news on a bug fix? Or maybe I should try and reinstall the update, maybe that would fix it?

[Dimitrios Kanellopoulos]

@barfoot what is the WHR version on your wathc ?

[Barfoot]

@dimitrios-kanellopoulos its a Sport Wrist Hr All Black. Or do you mean the Valencell version?

[Dimitrios Kanellopoulos]

@barfoot VAllencel version

[Barfoot]

@dimitrios-kanellopoulos Valencellsays 6571 in the settings. Am I looking in the right spot?

[Dimitrios Kanellopoulos]

@barfoot yup that is the latest.

[Ze Stuart]

This still seems to be a bit buggy in .42, Valancell 6571.

Observed: swipe to instant HR, a number is displayed. This number is usually static, then reverts to the 72 number.

Expected: dynamic number reflecting HR.

Bug, or are my expectations incorrect?

[SlaSh]

@ze-stuart static number is last your hr, 72 number is starting point before hr lock and this should go away as misleading customers

[sartoric]

@Ze-Stuart
Anyway, just wait 30 sec, more or less,than you should see hr refresh

[A Former User]

@sartoric said in [Watch] Instant HR on new firmware 2.0.40 (spartan):

@Ze-Stuart
Anyway, just wait 30 sec, more or less,than you should see hr refresh

30 secs are not instant HR. So, this is not working atm

[Shrek3k]

30 seconds should be the maximum time to fully initiate it, afterwards it should be “real real time”