- 
 @sartoric 
 Done 1h/1,5h activities
 GPS almost always on (Best)
 Energy saving, screen off (10sec)8,5 h => -21% 
- 
 @sartoric my last full charge is this morning at 10h. 2 hours later -2% 
 8 hours later -5%
 I run a 5km race for 20min withe best gps glonass off and whr on -8%
 It’s 22h, since this morning the watch has lost 17% of charge, the hard reset has obviously done good
- 
 update 29/05/2018: Last full charge 0% -> 100% on 26/05/2018. Just after having hard reset via Sunntolink 
 I used the watch in sports activity 4 times for a total time of 3:32.
 I sleep with the “DND” enabled.
 We are the 29/05/2018 and I have 12% of battery left.
 I always find the speed of discharge excessive.
- 
 @frédéric-fiandino don’t see any problem, looks like my Baro battery usage. You charge your watch via usb? 
- 
 Hi, I have 2 problems here. When i connect the watch via Suuntolink and upload a new move, the battery automatically drops a lot in my Spartan Trainer Wrist. Another problem is my watch when charging it will never reach 100% fully charge. It will stuck at 99%. When i disconnect the cable and re-connect it back again it will drop to 95% from 99%. Please advise. My watch and Suuntolink are latest version. 
- 
 @babychai 
 Did you already try to reboot the watch ?
- 
 @babychai 
 How long do you wait at 99%?
 Long enough?
- 
 @sartoric yes i reboot once but problem still same. 
- 
 @mff73 99% stuck at about 45 mins. i think last time can reach from 99% to 100% within 15 mins before the app update. 
- 
 @babychai Ok. Batteries should never reach 100% or overcharge no matter how long you have it to charge it will always stop at 99%. Trainers have less accurate batteries than the other Spartans. They measure on less precision. I would not worry neither leave my watch plugged in when it’s 100% nor would I empty it. Change full and deplete the battery 1nce per month 
- 
 Apologies, but my SSWHR definitely charged up to 100% without any issues and more or less “steadily”. I saw 95%, left the watch for probably 15 more minutes, and there were 100% (used a USB-port from my PC … as I usually just let it “hang” after synchronizing the activities to MC). 
- 
 @shrek3k WHR version is having different battery which calibration profile is more accurate. Do not compare with trainer. Anyway everyone needs to do full battery cycle (full charge/discharge/charge) time from time to calibrate the battery, this will improve battery percentage information accuracy. 
- 
 hello, i have done a full charge/discharge/charge cycle and the problem still continue. i lost 20% in 24h, and 40% during a 2h40 run. 
 I will try to downgrade the firmware to the v1.12.36 to see if the issue continue or not.
- 
 @gabriel-s 
 well … do you have 24/7 HR and sleep enabled ?
 20% in 24h doesn’t look so bad. It’s less then 1% per hour.
 Watch-face ?
- 
 Yes i have 24/24 HR enabled and the night i put the watch in DND mode. 
 The watch face is the outdoor like i have before the update, with the 1.12.36 version the watch loose 10/12% per day.
- 
 @gabriel-s 
 Maybe you can try changing watch face before downgrade.
 I always had the suspicion that the “outdoor” one is a bit “energy consuming”
- 
 @slash Got any fastest way to discharge the battery? Kinda slow if i just let it deplete by itself 
- 
 @babychai open GPS 
- 
 @dimitrios-kanellopoulos Haha…noted, thanks  
- 
 @babychai 
 … and turn light on
  




