Suunto Vertical 2 General Discussion

martintrail

@Jan-Suchánek Amazing. Thank you very much

Jan Suchánek

@martintrail You´re welcome. I’m glad I finally got to compare it. I can also do a visual comparison with the Fenix 8 51mm in future. My neighbour has it. I think those seemed brighter than the Fenix 7 Pro when I compared it in past.

Stefan Kersting

@Tieutieu actually I have a red light head torch that will do the job when outdoors from autumn to fall I never gå without my head torch in my backpack

Audaxjoe

@Stefan-Kersting where you live you’d need it from Autumn to Spring

Jan Suchánek

Comparison of two cycling commutes. These are two activities with almost the same speed and effort, but during the one with OHR I felt more tired. Yesterday’s activity with OHR is shown in red, today’s with the Polar H10 in blue. The average heart rate differs by 11 bpm — OHR probably showed a lower heart rate, but mainly it takes a long time to respond when going uphill. For me, I’ll only use OHR for walking at most. In any case, compared to the Race 1, this is a big improvement.

tommieboy

Does anyone know when the release date for the Vertical 2 is for Canada?

It’s advertised on the Suunto Canada website with price and specs but no information on when it can be purchased. The “Buy Now” button remains greyed out.

Thanks.

tuxbuster

I have noticed a few times now that the Suunto app (iOS) does not start syncing and says that the watch is busy, even though the watch only shows the home screen. I then have to go into a menu on the watch and back again, and then it works again.

It’s similar with the shortcuts. I use the upper right button with a long press for the flashlight. This shortcut does not respond when the watch is in this state.

This behavior usually occurs when the watch has not been actively used for a longer time (about an hour or more).

Software version: 2.46.12
Restarting the watch did not help.

Has anyone else noticed this?

Egika

@tuxbuster yes. this is a known issue.
together with the button lock that can’t be unlocked

martintrail

My wife bought me V2 as a surprise. So I’m in the club and I’m curious about the transition from V1.

VoiGAS

@martintrail What a wife - congratulations !

brekke89

I’ve just switched from a Garmin Forerunner 265 to the Suunto Vertical 2. I really like the Vertical, and the Suunto ecosystem is much more intuitive and informative!

The only thing that annoys me is that the watch never disconnects from Bluetooth, even when I put it in flight mode. I still receive notifications, and it keeps syncing with my phone all the time. How do you completely disconnect it from the phone? I’ve tried restarting the watch. Any suggestions?

krakra

Hey all! I am tempted to upgrade from s9pp to V2. Really like the fact that i can see a lot of data on watchface without turning on or even move wrist to display all that info. I also fond watch more attractive to look at since it is not only black screen.
Anyone upgrading from mip find amoled annoying as edc watch?

VoiGAS

@krakra I upgraded from 9P to RaceS. As a watch the AMOLED Display works quite good in Always On Mose. Only in bright Sunlight you need to wake it, but it has a light sensor.
The problem is more during activities, where Lift to wake takes some time and the AOD display is too dim during the day. But if you are running before sunrise and after sunset the AMOLED Display wins easily

Egika

@brekke89 said in Suunto Vertical 2 General Discussion:

I’ve just switched from a Garmin Forerunner 265 to the Suunto Vertical 2. I really like the Vertical, and the Suunto ecosystem is much more intuitive and informative!

The only thing that annoys me is that the watch never disconnects from Bluetooth, even when I put it in flight mode. I still receive notifications, and it keeps syncing with my phone all the time. How do you completely disconnect it from the phone? I’ve tried restarting the watch. Any suggestions?

apparently there are two “flight modes”.
one you access from the control panel -> does not stop BT
and one you access from setting -> communication -> stops BT

Audaxjoe

@krakra I have the V2 from V1. In everyday use the V2 is fantastic. Clear, bright and with colour. Looking at the V1 after the V2 makes the V1 look very old…

However when cycling the MIPs is far superior.

On the V2 with AOD the map still goes dark and isn’t brilliant to read. I haven’t tried it walking yet but imagine it will be brilliant for that as you raise your to wrist to view.

Initial reaction to the V2 was too send it back with the cycling performance after a few days as an everyday watch I wouldn’t want to go back to the V1… I do have a bike computer from wahoo so the comparatively poor performance on the bike isn’t a big deal.

krakra

Any chance to demonstrate how dim modes work in navigation activity mode?

brekke89

@Egika said in Suunto Vertical 2 General Discussion:

@brekke89 said in Suunto Vertical 2 General Discussion:

I’ve just switched from a Garmin Forerunner 265 to the Suunto Vertical 2. I really like the Vertical, and the Suunto ecosystem is much more intuitive and informative!

The only thing that annoys me is that the watch never disconnects from Bluetooth, even when I put it in flight mode. I still receive notifications, and it keeps syncing with my phone all the time. How do you completely disconnect it from the phone? I’ve tried restarting the watch. Any suggestions?

apparently there are two “flight modes”.
one you access from the control panel -> does not stop BT
and one you access from setting -> communication -> stops BT

Thanks! It is working now

Elipsus

@Egika Oh ! that explains a lot ! Is it planned for future bugfixes ?

Jan Suchánek

@Elipsus It´s intended design by Suunto as I read somewhere… I can´t understand that.

Egika

@Elipsus don’t know if this will change. At least this is pretty unintuitive.
reported it to Suunto