Suunto Vertical 2 General Discussion

[martintrail]

@HonzaS Yes, lately I’ve also been getting some strange data from ZS…

[HonzaS]

@martintrail Short time IMHO for analyze.

[Elipsus]

@HonzaS yes, but that doesn’t excuse providing garbage data, if ZoneSense calculate this, then it shouldn’t display it…its the most basic data validation you can do !

[Sportsfreund]

@martintrail no, it never left beta status. In my case!

[HonzaS]

Last months I got very slow charging on my V2. Today I started charging at 26% and now after almost 3 hours I got 95%. I tried three types of chargers but it’s the same. Does anybody has same problem?

[VoiGAS]

@HonzaS Try a soft reset after you fully charged it. In my case the display changed to 100%. There are always problems with the battery calibration, especially after updates

[HonzaS]

@VoiGAS I tried that few times while charging. The percentage doesn´t change but the charging was maybe speeded up. It´s not the problem of stuck at the value before full charge. On next charging, I´ll try to reboot before charging if it helps.

[johann.fuehrer]

@HonzaS Hello, you need to soft-reset AFTER the charging. This fixed it for me. But actually - since the latest firmware the issue has vanished on my V2.

[HonzaS]

@johann.fuehrer I also did that. But how could reboot performed AFTER charging solve slow charging speed BEFORE this reboot?
Also next charging was the same, that’s why I wrote that I’ll try to reboot BEFORE charging…

[HonzaS]

I’m facing another bug. HR recovery measure doesn’t start after ending activity even if it’s enabled. Sometimes it starts, sometimes not.

[VoiGAS]

@HonzaS Did you check that you are in Zone 2 or higher at the end of the run? Else your HR is already too low and it doesn’t start

[HonzaS]

@VoiGAS Hey! So that’s it! I was wondering if I already read that somewhere, but can’t find it. That was surely the case! Thanks!