Battery drain

SamuelP

@GKnoll just long press the lower button to acces the “control panel”. It shows “battery %” and “hours left”

BrunoH

@Samuel-Pirttikangas a quick reminder. Not all of us have Control Panel configured to the lower button long press. I used to have, but I had to change it because of the Control Panel carousel rendering problem. The problem stopped when I moved it to mid button short press. Weird, I know!

Sportsfreund

@BrunoH er meint wenn du die untere Taste während einer laufenden Aktivität gedrückt hälst.

SamuelP

@BrunoH i ment if you hold down the bottom button during an ongoing activity then you get battery stats.

GKnoll

@Samuel-Pirttikangas Thank you!

MarioPedraza

@OnlyoneKenobi Oops, sorry. Mine goes to technical support on Tuesday. I’ll cross my fingers.

Abu bakar Umar

@Klaane said in Battery drain:

The battery on my Suunto Vertical Solar has dropped from fully charged to 55% in only two days. Last night it dropped by 15% while I was sleeping with the watch on.
I have mobile notifications and 24/7 HR turned on but it still shouldn’t drain that fast, right? Standby backlight is off and I’ve used GPS for less than 10 minutes during those two days.
Do I have a defective battery or could this be some other issue?

It sounds frustrating! While mobile notifications and 24/7 HR can drain the battery, a 15% drop overnight seems excessive. Try resetting your watch or updating the firmware. If the issue persists, contacting Suunto support might help.

Devil Scheme

This post is deleted!

Nicolas Marseille

Hello everyone, since last firmware update to 2.50.26 version battery drain issue is strongly back ! Almost 10% per day ! This was a solved issue since months…
Do you know any way to rollback to a former firmware. The previous one was perfect from my point of view.

ggrego

@Nicolas-Marseille bonjour Long press the middle button to access the settings.

• Select general.

• Select about.

• Scroll down until you see data privacy at the end.

• Long press the bottom button to access the interface.

Scroll down and select

“Select the OTA package”.

You can see the current version and the previous version here.

Select the previous version to update

GKnoll

Re software 2.50.26: During last week’s Spine Challenger North I found that, after maybe a day of continuous tracking, when I had the navigation screen showing the backlight would turn on, often at high intensity, if I apparently raised my wrist - but I had disabled this function under General Settings and confirmed this post-event. Wrist raises occurred often because of the terrain so the backlight kept turning on. This caused me great concern because of the obvious effect on battery life and the need for good navigation at night up on the mountains in bad weather.

I also note that if I select ‘endurance’ gps accuracy (that is, ‘good’ rather than ‘best’) only breadcrumb navigation is now available, whereas in the previous software version I could select outdoor mapping for navigation for ‘good’ gps (that, I found, is perfectly adequate for navigation in open countryside). Was this change a bug fix or was it to remove an apparently better battery life than the Vertical 2 in the good/endurance gps mode?