Suunto Vertical 2 General Discussion

krakra

Hi! Just wanna check what is the verdict for this “issue”? - see link below.
Anyone got official suunto statement for this?
Before i buy v2 wanna be sure if this is handled as defect or something what is normal to expect? Thanks

Source: https://forum.suunto.com/topic/13844/suunto-vertical-2.-rotating-display-inside-the-watch-case/6

krakra

Got suunto support update regarding this issue:

“The discussion you found dates back to 2025, when a limited number of early units showed this behavior and were reported by some users online. Since then, this has been fully addressed, and current production models have gone through updated quality control processes”

GratefulDeadpan

@krakra said:

Got suunto support update regarding this issue:

“The discussion you found dates back to 2025, when a limited number of early units showed this behavior and were reported by some users online. Since then, this has been fully addressed, and current production models have gone through updated quality control processes”

I can unfortunately say that this is still an issue with V1, not sure how widespread but I just bought a new one from Suunto and the display on mine is tilted.

Mff73

@gratefuldeadpan
Serial number of that new watch? Maybe an “old” stock…

GratefulDeadpan

@Mff73 said:

@gratefuldeadpan
Serial number of that new watch? Maybe an “old” stock…

2548C8001018

Not sure how to look it up but if you know I’d appreciate any help. Returning this and ordering a new one.

SergioB

@GratefulDeadpan First two digits are the year, second couple should be the week. So in your case is the 48th week of 2025

GratefulDeadpan

@SergioB thanks, appreciate it! That doesn’t sound like Suunto did a very good job of clearing up their QC though as I believe they claimed having sorted this issue for the V2 before then?

Squirrel

@GratefulDeadpan said:

I can unfortunately say that this is still an issue with V1, not sure how widespread but I just bought a new one from Suunto and the display on mine is tilted.

Ok, so you have a tilted display on Vertical 1, or is that a typo?

GratefulDeadpan

@Squirrel correct, not a typo.

Colomers

My Vertical 2 crashes only during activities (2 or 3 times a week), which is quite annoying. I thought the last update would fix the issue, but that doesn’t seem to be the case.
Has anyone else experienced this issue? If so, have you found a workaround?

I tried to send the logs to suunto without succes.

runyx17

@Colomers During the last 14 days, my watch has been restarting many times, both during active tracking and in normal daily use. I have already sent logs 3 times, but I have not received a meaningful response from Suunto yet. This is very frustrating.

Highlands

I’ve had my V2 since mid October and so far not a single crash. I always run 3 S+ non-third party apps. No other issues either.

HonzaS

Today’s 15 minutes commute to work. Anaerobic threshold lower than aerobic .

martintrail

@HonzaS Yes, lately I’ve also been getting some strange data from ZS…

HonzaS

@martintrail Short time IMHO for analyze.

Elipsus

@HonzaS yes, but that doesn’t excuse providing garbage data, if ZoneSense calculate this, then it shouldn’t display it…its the most basic data validation you can do !

Sportsfreund

@martintrail no, it never left beta status. In my case!

HonzaS

Last months I got very slow charging on my V2. Today I started charging at 26% and now after almost 3 hours I got 95%. I tried three types of chargers but it’s the same. Does anybody has same problem?

VoiGAS

@HonzaS Try a soft reset after you fully charged it. In my case the display changed to 100%. There are always problems with the battery calibration, especially after updates

HonzaS

@VoiGAS I tried that few times while charging. The percentage doesn´t change but the charging was maybe speeded up. It´s not the problem of stuck at the value before full charge. On next charging, I´ll try to reboot before charging if it helps.