race 2 + HR strap = :/
-
sooo i dug out from the bootom of the closet my over 10 years old suunto smart hr belt. itâs rusty, it smells like hell, no amount of soap can wash the smell off⊠but at least it works
looks like if you donât wanât the troubles, go with suunto strap 
-
@Nikolai
I have previously had some issues with H10. Invariably they were traced to wear on the inside of the strap itself, not the actual unit. I found the strap wore out after perhaps six months of use (maybe 5 runs a week on average). If you turn the strap inside out and gently fold it back against itâs normal curvature you might notice tiny cracks in the sensor pads. These often arenât visible the âright way roundâ. A new strap (even a compatible cheap one from eBay) usually solved the problem.
Hope this helps. -
@MarkG thank you very much for the proposal.
I am almost certain that it is a problem of the watch, because I have been using Polar H10 strap for the past 4 years with two Garmin watches and I never had any issues.
The battery on the strap is brand new.
I am disappointed.
I have switched to Polar verity sense which seems to work much better with the watch. -
@Nikolai
Cheers Nikolai. Iâve also got a verity sense which is what I use virtually all the time and have had no problems with it at all. However I might be going back to the H10 to give Zonesense a try once Santa brings my V2.
Shame the Polar wonât work with it - I find it a lot more convenient and reliable and all my HR readings correspond with what I expect after years of using chest straps. -
@MarkG good luck with that!
Please share your experience with the H10 once you have done some workouts -
MĂȘme problĂšme : une fois sur deux la Suunto Race 2 ne sâappaire pas Ă la Polar H10 et quand elle le fait si je fais 2 sĂ©ances distinctes, la Race ne veut plus sâappairer Ă la H10 la seconde fois. Câest un peu Ă©nervant. 1Ăšre fois que je rencontre ce problĂšme avec une montre et jâen ai eu pas mal (Apple, Polar, Coros, Garmin). Câest Ă©trange. Par contre toutes mes ceintures Garmin sâappairent tout de suite ou presque Ă la Race 2.
-
@herlas said in race 2 + HR strap =
:current design to connect to HR devices is for each sports mode to remember the HR device it connected to and next time you open the same sport mode itâll try to connect automatically to that device only
Thatâs how it is supposed to work, but it doesnât quite work that way. Hereâs an issue that I have just experienced today:
On my trail run profile, the watch is paired to Coros HRM. On my road run profile the last few times I used the built-in wrist HR sensor.
Yesterday I couldnât find find my Coros HRM so I used the run profile with the built-in HRM. Today as I was wearing Coros HRM and about to start a trail run, the watch showed a popup telling me that Coros HRM was connected. Good! But since the run profile was preselected, it was flashing the built-in HRM icon trying to obtain the lock. OK, since that was the wrong sport profile, I went ahead and changed the profile to trail run. Nevertheless the watch continued to try to obtain the built-in HRM lock rather than switching to Coros HRM, despite the fact that the built-in HRM is explicitly turned off for trail run profile. So basically it was stuck - trying to use built-in HRM without success because it is turned off rather than using Coros HRM that it told me it has already successfully connected to. What a mess! To me this looks like this has never been properly tested!
In the past when I tried to use a mix of Coros HRM and Suunto HRM on different profiles, it was even worse.
-
I use the Race 2 with Wahoo HR strap and it works with no issues. The strap connects to my bike computer and the watch when I ride, or just to the watch when I XC ski.
-
Lately, I started seeing strange HR numbers on my SR2. I am using a Wahoo strap (TRACKR). When I bike, the HRM strap is connected to the SR2 and to a Garmin Explorer cycle computer. The bike computer shows pretty normal data, but the watch shows numbers that vary greatly. Most of the time the numbers are very high, occasionally, it seems like the number is stuck (it is not changing regardless of the effort); on other occasions, the numbers can be much lower.
Honestly, it does not make much sense - the HRM should be transmitting the same data to both devices. Also, i assume that if the HRM is connected, it should be transmitting proper data or nothing at all.
Could anyone provide any insights? Ideas how to troubleshoot it? Is this a problem with the HRM strap or the watch? ??? -
@MdzOtt check the r-r- plot, I think the strap is not working properly
-
@isazi a silly question: the r-r plot? (Regression??). Where can I get it?
-
@MdzOtt it is not in Suunto App, check Runalyze or quantified-self.io
-
Tengo el mismo reloj y la misma banda, no me pasa tan seguido pero cuando me sucede, sobre todo que no se conecta al reloj, quito y pongo la pila del sensor y eso soluciona el problema, no me ha pasado que pierda señal en medio de una actividad, lo que a veces es me pasa es que marca pulsaciones o mucho muy elevadas o mucho muy bajas pero es cuestión de unos cuantos segundos (a veces un par de minutos) y regresa a las mediciones normales, si es un problema pero aprendà a vivir con esto ya que nadie nos dice o nos da una solución de raiz.
-
@Victor-Hugo-Santoyo Kind of, what i do. It is not a big issue, especially with a bike computer available, but i would like to see some solution for the winter season (XC skiing).
-
@isazi thanks for the suggestion
-
@isazi it seems that for the first half of the activity, the watch recorded HR that was substantially higher than âreasonableâ. After i stopped for a few mins, it started working âcorrectlyâ. I did not find anything âspecialâ in quantifiedself, or in Runalyze. The HR graphs look normal other than some 20% too high.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better đ
Register Login